linco has created a new 2 meter HT that sets new standards in features, convenience and easy operation. The DJ-195/196 sports an alphanumeric display for easy memory management. It has an ergonomic design that's "user friendly" and the 5 watt output battery is standard. You'll be ready to travel the world with CTCSS encode+decode, DCS and European tone bursts, all included at no extra cost. Best of all, the DJ-195/196 retains the proud Alinco tradition of quality construction and excellent value.
• Alphanumeric display
• 40 memory channels
• 5 watt output with standard battery
• CTCSS encode+decode and DCS
• 13.8 VDC direct input with battery charge feature
• Direct frequency input
• S-meter
• Autodialer
• Cable Cloning
• Computer programmable (third party software required)
• MARS/CAP capability (DJ-195T/196T)
• Additional features, including theft alarm!
• Back-lit keypad (DJ-196T Only)
Alinco DJ-195T/196T 2 Meter HT
Alphanumeric Display | Label channels in an easy-reading format. Display frequency, alpha label or channel number only. |
40 Memory Channels | Plenty of room to store your favorite simplex or repeater frequencies along with alphanumeric label, offset, CTCSS encode/decode or DCS setting. |
5 watts output | The standard battery allows the DJ-195/196 to produce up to 5 watts. A power input port
Accepts 13.8 VDC and charges the battery, but won't allow destructive overcharge. |
CTCSS, DCS, Tone Bursts and DTMF | Be prepared for virtually any selective calling situation or gaining access to repeaters with protected inputs. European Tone Bursts include 1000, 1450, 1750 and 2100 Hz. |
Direct Frequency Input | Frequency entry is easy using the well-spaced keypad. |
S-Meter | Displays relative signal strength. |
Cable Cloning | Share identical settings among multiple DJ-195/196 transceivers. Saves time and ensures uniform operation. |
Removal Alarm | The DJ-195/196 can be set to emit a tone when disconnected from an external power source until proper action is taken to silence the alarm. |
Experimental Insect Repel Feature | Can the DJ-195/196 actually repel mosquitoes? Activate the special tone and decide for yourself! You may find the DJ-195/196 can "de-bug" your outdoor operating site! |
SPECIFICATIONS
General | DJ-195T/196T |
Freq. RX original status | 130 to 174 F2 F3 only |
F2,F3,WFM | |
Freq. TX | 144-147.995 |
F3 | |
Freq. Stability | +/-5ppm(-10 to +60c) |
Antenna Imp. | 50 ohm unbalanced |
Supply Voltage | DC 13.8V rated |
DC 6.0min to 16V max | |
Ground | Negative GND |
Current consumption | TX 5W 1.2A approx. |
at 13.8V external source | RX 200mA approx/300mW |
RX squelched 50mA approx. | |
RX Batt.Save on 20mA app. | |
Operating Temp. range | -10 to +60 degrees C. |
Dimention w/o projection | 56(W) x 124(H) x 40 (D) |
Weight with drycellcase+cell | N/a |
and antenna | |
Transmitter | |
Output power | 5W 13.8V or EBP48N |
Low=0.5W | |
Modulation | Variable reactance |
Max. Deviation | n/a |
Spurious emission | less than -60db |
Microphone Imp. | 2k ohms approx. |
Receiver | |
Circuit | Double superheterodyne |
1st IF freq. | 21.7Mhz |
2nd IF freq. | 450khz |
Sensitivity 12db SINAD | better than -8dbu |
(0.2uV or less) | |
Selectivity except WFM | more than -6db/12khz |
less than -60db/28khz | |
Image/spurious response | less than -60db |
AF out at 10% distort.13.8V | Max 300mW |
AF impedance | 8 ohms |
Standard feature | |
Expandible RX range | none |
MARS/CAP mod. | Yes |
DTMF | tone encode |
DCS SQ | enc/dec |
CTCSS SQ | Enc/Dec 39tones |
Memory ch. | 40ch non expandible |
Auto Dialer memory | memory 9 memories, max |